PHONE (425) 451-8565

Quiet Wing System

Aircraft Induction Checklist for B727 Series Hush Kit, Performance System and Winglets

PLEASE READ THE FOLLOWING INSTRUCTIONS VERY CAREFULLY.

Note: It is vital that the following information is accurate and current for your airplane. Failure to provide this information may result in delays in completing your airplane on schedule.

Name /
Company
Checklist
Completed by
Title Phone
Fax Email
1. Quiet Wing System Kit Configuration Number
Includes Winglets? Yes No
2. Aircraft Model Number 3. Aircraft Line Number
4. Registration Tail Number Aircraft Serial Number
5. Please list the part number, model number, position, and serial number of the current Flap Position Indicators.
Boeing P/N OEM P/N S/N Inboard
Boeing P/N OEM P/N S/N Outboard
6. Located next to the gear retraction handle, what does the Gear Retraction Speed Placard indicate?
Extend Knots Mach  
Retract Knots Mach  
Extended Knots Mach  
7. List the part numbers for the engine nose cowls:
Position No. 1 P/N Position No. 3 P/N
8. List the part numbers for the engine tailpipes:
Position No. 1 P/N Position No. 2 P/N
Position No. 3 P/N
9. Which of the following isolators are installed? (for JT8D-17 series engines only)
Elastromeric Met-L-Flex
10. Tail Logo Light Kit option. This is an option and is not part of the Quiet Wing System Kit. Does the Customer request this option for an additional cost?
Yes No
11. Does the aircraft have a Performance Data Computer?
Yes No
12. What type of thrust reversers are installed on the aircraft?
A. Cascade Clamshell
B. Do you have a thrust reverser on the #2 Engine? Yes No
13. List the part number of the #2 Engine Power Lever:
P/N
Is there a 70% detent on this lever? Yes No
14. What is the condition of the Compression Seal, Mid Flap to Aft Flap? Check one:
Very Good Good Poor Needs Replacing
15. Does the aircraft have flaps 20 degree position? Yes No
Note: Verify the 20 degree position on the Flap Position Indicators, Control Panel Placards and Control Stand Detent Lightplate or Placard. Please note any differences below:
16. List the engine models as follows:
Position No. 1 Model No Position No. 2 Model No
Position No. 3 Model No
17. Is your aircraft Post Service Bulletin No. SB27-178? Yes No
17. Is your aircraft Post Service Bulletin No. SB31-0056? Yes No
19. Please provide a hard copy or scanned legible copy via e-mail of the following Aircraft Flight Manual pages:
 
A. AFM Title Page
B. AFM Log of Pages (all)
C. AFM Appendix Pages (all)
D. AFM Section 1 Certification Limitation Pages (all)
E. AFM Weight and Balance Pages
 
20. Please provide a hard copy or scanned legible copy via e-mail of the following wiring diagrams:
 
A. Mode A/B Aural Warning System
B. Flap Position Warning (specifically 27-43-01 all)
C. Take Off/Landing Warning System (specifically 31-26-XX all)
D. LDG Position Warning-Green Lights (specifically 32-64-01 all)
E. LDG Position Warning-Horn (specifically 32-64-03 all)
 
21. Have there been ANY CHANGES to the airplane’s baseline configuration from Boeing, to the Ground Proximity System (via an STC modification, etc.)?
Yes No
(Note: If yes, please provide a hard copy of all Wiring Diagrams and Maintenance Manual changes (Ref. ATA 34))
22. Have there been ANY CHANGES to the airplane’s baseline configuration from Boeing to the Auto Pilot System (via STC modification, etc.)?
Yes No
(NOTE: If yes, please provide a hard copy of all Wiring Diagrams and Maintenance Manual Changes (Ref. ATA34))
23. Please provide current Aircraft principle weights:
MRW MTOW MLW MZFW
24. Is the aircraft currently Stage III noise certified? Yes No
25. If yes, who is the manufacturer of the hush kit?
Quiet Wing Technologies (DuganAir) FedEx Raisbeck


Additional Information and Parts Required for Winglet Configurations Only

27. Please list part number, model number, and position (Capt or F/O) of the current Mach /Airspeed Indicators and Aural Warning Switches:
(Capt) Boeing MASI P/N OEM P/N S/N
(1st Off) Boeing MASI P/N OEM P/N S/N
Aural Warning Switch P/N S/N Aural Warning Switch P/N S/N
Standby ASI Indicator: If MASI installed in this position in lieu of Airspeed only Indicator, identify:
Boeing MASI P/N OEM P/N S/N
For airplanes with individual Mach & Airspeed Indicators installed, identify Standby ASI Indicator:
Boeing MASI P/N OEM P/N S/N
28. Navigation Light System.
A. Does the wingtip have strobe lights installed? Yes No
B. If yes, are they dual stacked? Yes No
C. Is the Aft Position Light: incandescent only or strobe/incandescent
D. Are Logo Lights requested? (additional cost, with winglets only) Yes No
As we move forward with this project please be ready to provide the following required aircraft documents and parts:
  • Flux Valves; Navigation Lights and MASIs
  • Flap Position Indicators (Inboard and Outboard)
  • Flap Detent Lightplate (B727-200 only)
  • Mach Air Speed Indicators (2) and - Mach Air Speed Switches (2) (Winglet Configurations Only)

Printer Friendly copy of form Here